Service Preparations; Logo Plate - Compaq AP200 Maintenance And Service Manual

3-2 Removal and Replacement Procedures

Service Preparations

Before beginning any of the removal and replacement procedures, complete the
following steps:
1. Turn off the workstation.
2. Disconnect the power cord from the grounded AC outlet and then from the workstation.
IMPORTANT: On a power-managed system, the power cord MUST be disconnected from
the grounded AC outlet.
3. Turn off all peripheral devices and disconnect cables from the rear of the workstation.
NOTE: For more information on preparing the workstation for service, see Chapter 2.

Logo Plate

To remove the logo plate, grasp the open side of the logo plate (left side if a desktop, bottom if
a minitower) and pull outward.
Figure 3-2. Removing the logo plate
To install a new logo plate, align the guide pins in the slots, then press into place.
NOTE: When replacing the logo plate, be sure the pins are properly placed in the front bezel
before pressing the logo plate into position.
CAUTION: Electrostatic discharge can damage electronic components. Be sure
you are properly grounded before beginning any installation procedure. See
"Electrostatic Discharge" in Chapter 2 for more information.