4.3-Gb Wide-Ultra Scsi Hard Drives - Compaq AP200 Maintenance And Service Manual

4.3-GB Wide-Ultra SCSI Hard Drives

Drive Size:
For Hot-Pluggable Drive Tray, connect
SCSI ID Cable to this Connector
Pin 1
Pin 1
NOTES:
1. All jumper and switch settings are
shown in the factory default setting,
including those not labeled.
2. Termination default is disabled/removed.
Figure 6-4. Jumper positions for the 4.3-GB hard drive (WDE4360W)
4.3 GB
Bit 1
Pin 1
Printed
Circuit
Board
SCSI
J1B
POWER
WDE4360W
Model:
SCSI ID Settings
SCSI ID Bit 2 Bit 1
0
1
2
3
4
5
6
Jumper NOT Installed
Key
Jumper Installed
Default Settings
Signal Description
S Start Unit Command Enabled
Parity Enabled**
W Write Protect Disabled
X Synch Data Transfer Enabled
Key Jumper NOT Installed ** Not Configurable
Jumper Installed
J1B
Pin 1
For Hot-Pluggable Drive Tray, connect
SCSI ID Cable to this Connector
Compaq Professional Workstation AP200 Maintenance and Service Guide
6-5
Bit 0
Jumper
n/a
n/a