Power Switch - Compaq AP200 Maintenance And Service Manual

Power Switch

To remove the power switch and switch holder:
1. Perform the service preparations shown on page 3-2.
2. Remove the access panel.
3. Disconnect the power/LED cable from the system board.
2
4. Push the release tab toward the drive bays
chassis
1
Figure 3-32. Disconnecting and removing the power switch and switch holder
To reinstall the power switch, reverse the above procedure, pushing the power switch until it
snaps into place.
CAUTION: The power switch should not be removed from the switch holder.
Doing so may damage the switch components.
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.
.
1
, then remove the power switch from the
2
Compaq Professional Workstation AP200 Maintenance and Service Guide
3-31