Service Considerations; Tool Requirements - Compaq Presario 5UV430 Maintenance And Service Manual

Compaq Presario Internet PC 5000 Series Computers
PRODUCT DESCRIPTION
REMOVAL AND REPLACEMENT PROCEDURES

Service Considerations

ELECTROSTATIC
DISCHARGE

Tool Requirements

SERVICE
CONSIDERATIONS
PREPARATION FOR
DISASSEMBLY
SERIAL NUMBER
Screws
SIDE ACCESS PANEL
The screws used in these products are not interchangeable. If an incorrect screw is used during
GRAPHICS CARD
the reassembly process, it could cause damage to the unit. Compaq strongly recommends that
EXPANSION CARD
all screws removed during the disassembly process be kept with the corresponding part that was
(Modem or Network
removed, then returned to their proper locations.
Card)
1394 CARD
MEMORY MODULE
HARD DRIVE Cables and Connectors
Most cables used throughout the unit are ribbon cables. These must be handled carefullyto avoid
DISK DRIVE
damage. Apply only the tension required to seat or unseat the cable during its insertion or
removal from the connector. Handle cables by the connector whenever possible. In all cases,
REMOVING THE TOP
avoid bending, twisting, or tearing the cables, and ensure that they are positioned so that they
DOOR
cannot be caught or snagged by parts being removed.
REMOVING THE CD
STORAGE DOOR
(Lower Front Panel -
Open the CD Storage
Door)
JUMPER AND SWITCH INFORMATION
Phillips screwdriver
1.
Needle-nose pliers
2.
Flathead screwdriver
3.
Compaq Utilities software
4.
As each subassembly is removed from the computer, it should be
Important
placed away from the work area to prevent damage.
When servicing these computers, ensure that cables are placed in
CAUTION their proper location during the reassembly process. Improper
cable placement can cause severe damage to the unit.
TROUBLESHOOTING
United States
REMOVAL AND REPLACEMENT PROCEDURES
ILLUSTRATED PARTS CATALOG
SPECIFICATIONS