Intermec Shell Overview - Intermec EasyCoder PF4i User Manual

Chapter 8—Intermec Shell Startup Program
Intermec Shell v8.1 Overview
POWER ON
ENTER=SHELL
5 sec. v.8.1
ENTER=SHELL
4 sec. v.8.1
ENTER=SHELL
3 sec. v.8.1
ENTER=SHELL
2 sec. v.8.1
ENTER=SHELL
1 sec. v.8.1
Last selected
application is started
Default:
Fingerprint 8.20 w. std I/O = "auto"
Legend:
Return to previous menu.
Proceed to next menu.
Accept displayed option
and proceed, or
execute displayed option.
Perform a Testfeed
anywhere in Intermec Shell.
Enter the Setup Mode
from anywhere
in Intermec Shell.
82
SHELL
SEL. APPLICATION
SHELL
SETUP
SHELL
PRINT SETUP
SHELL
TESTFEED
SHELL
TEST LABEL
SHELL
DEFAULT SETUP
SHELL
SOFTWARE UPDATE
SHELL
REBOOT
Restarts the printer (same as power off/on)
Intermec EasyCoder PF4i—User's Guide (Fingerprint version)
SEL. APPLICATION
CURRENT APPL.
SEL. APPLICATION
Note: Dotted channels are only shown if
Fingerprint 8.20
the corresponding optional interface pcb
is fitted.
STD I/O CHANNEL
SEL. APPLICATION
auto
Direct Protocol
STD I/O CHANNEL
uart1:
STD I/O CHANNEL
uart2:
STD I/O CHANNEL
uart3:
Optional application
programs
STD I/O CHANNEL
centronics:
STD I/O CHANNEL
net1:
STD I/O CHANNEL
usb1:
SEL.APPL rom:
LINE_AXP.PRG
SETUP:
See the chapter "Setup Mode"
SER-COM,UART1
Prints a list of current setup values (test label "Setup Info").
Performs a Testfeed (feeds out a number of blank copies
while autoadjusting the label stop sensor).
Prints test labels "Diamonds", "Chess", "Bar Codes #1", and "Bar Codes #2" in a loop
Press Enter for each new label.
ARE YOU SURE? DEFAULT SETUP
YES=ENTER/NO=ESC PERFORMED
UPDATE: TRANSFER FILE
COMPACT FLASH? USING ZMODEM
TRANSFER
COMPLETED
UPDATE: TRANSFER FILE
FIRMWARE? USING ZMODEM
Last selected application is started
Printer rebooted
automatically.