Intermec Shell V8.1 Overview - Intermec EasyCoder PF2i User Manual

Intermec Shell v8.1 Overview

POWER ON
ENTER=SHELL
5 sec. v.8.1
ENTER=SHELL
4 sec. v.8.1
ENTER=SHELL
3 sec. v.8.1
ENTER=SHELL
2 sec. v.8.1
ENTER=SHELL
1 sec. v.8.1
Last selected
application is started
Default:
Fingerprint 8.20 w. std I/O = "auto"
Legend:
Return to previous menu.
Proceed to next menu.
Accept displayed option
and proceed, or
execute displayed option.
Perform a Testfeed
anywhere in Intermec Shell.
Enter the Setup Mode
from anywhere
in Intermec Shell.
EasyCoder PF2i Bar Code Label Printer User's Guide (Fingerprint Version)
Chapter 8 — Intermec Shell Startup Program
SHELL
SEL. APPLICATION
SEL. APPLICATION
CURRENT APPL.
SEL. APPLICATION
Fingerprint 8.20
SEL. APPLICATION
Direct Protocol
Optional application
programs
SEL.APPL rom:
LINE_AXP.PRG
SHELL SETUP:
SETUP SER-COM,UART1
SHELL
Prints a list of current setup values (test label "Setup Info").
PRINT SETUP
Performs a Testfeed (feeds out a number of blank copies
SHELL
while autoadjusting the label stop sensor).
TESTFEED
SHELL Prints test labels "Diamonds", "Chess", "Bar Codes #1", and "Bar Codes #2" in a loop.
Press Enter for each new label.
TEST LABEL
SHELL
ARE YOU SURE?
DEFAULT SETUP
YES=ENTER/NO=ESC
SHELL UPDATE:
SOFTWARE UPDATE COMPACT FLASH?
SHELL UPDATE:
REBOOT FIRMWARE?
Restarts the printer (same as power off/on)
Last selected application is started
Note: Dotted channels are only shown if
the corresponding optional interface pcb
is fitted.
STD I/O CHANNEL
auto
STD I/O CHANNEL
uart1:
STD I/O CHANNEL
uart2:
STD I/O CHANNEL
uart3:
STD I/O CHANNEL
centronics:
STD I/O CHANNEL
net1:
STD I/O CHANNEL
usb1:
See the chapter "Setup Mode"
DEFAULT SETUP
PERFORMED
TRANSFER FILE
USING ZMODEM
TRANSFER
COMPLETED
TRANSFER FILE
USING ZMODEM
Printer rebooted
automatically.
85