Fuel Pump Removal (Te - Txc) - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
2
4
3
3
7
5
6
2
GENERAL PROCEDURES
Fuel pump removal (TE – TXC)
- Remove the fuel tank as described in the relevant paragraph.
- Remove the tank filler cap and pour the fuel contained in the tank into a ves-
sel of adequate capacity.
- Make use of a 10 mm wrench to slacken the 4 screws (1) of the pump flange
(2) and the four screws (3) of the fitting flange (4).
1
H02340
- Slide the fitting flange (4) out of the tank, then remove the delivery and return
hoses by releasing the quick fittings (5) and (6).
- Disconnect the pump supply connector (7).
4
H02341
- Slide the pump (2) with relevant small hoses out of the tank.
NOTE: To refit the pump follow the removal reverse procedure and make
sure that the seals under the flanges (2) and (4) are not worn.
H02342
E.17
Workshop Manual Ed. 07-2012