TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
FIGURE A
INTAKE
FIGURE A
INTAKE
FIGURE B
OUTLET
FIGURE B
OUTLET
Workshop Manual Ed. 07-2012
SETTINGS AND ADJUSTMENTS
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Use a thickness gauge to make sure that the clearance is equal to 0.15 mm for
the INTAKE side (Figure "A") and 0.20 mm for the OUTLET side (Figure "B").
If not so, remove the shim from under the valve bucket and measure its thickness.
Depending on what you find, replace the shim with a new shim with the required
thickness to achieve correct clearance (replacement shims are available in a
1.60 mm to 2.60 mm thickness range, in 0.05 mm increments).
Check valve clearances again. If clearances are correct, refit the parts you have
removed reversing the disassembly procedure.
For camshaft disassembly and reassembly, see Section "F" Engine disassembly
and Section "H" Engine assembly.
H10953
H10954
H10955
H10956
D.8