Kick Start Assembly - Husqvarna 2013 TC 250R Workshop Manual

ENGINE REASSEMBLY
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Kick start assembly

Refit the starter ratchet release plate (1) (use a 4 mm wrench, 8 Nm, 0.8 Kgm,
5.8 ft/lb, Loctite 243).
Fit the complete shaft assembly (2) to its seat (B) in the crankcase, making sure
the ratchet is correctly positioned on the shaft (marks lined up) and insert the
spring end (3) into the hole (D).
Fit transmission gear (4), washer (5) and snap ring (6).
Workshop Manual Ed. 07-2012
H.31