Husqvarna 2013 TC 250R Workshop Manual page 249

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
2A
B
BRAKES
- Remove the reservoir cover (2) or (2A) and the rubber gaiter.
- Pull the lever (3) and hold it pulled, or press the pedal (3A) and hold it pressed
so that the system is under pressure.
- Loosen the valve (1) or (1A) and wait for the oil to come out, then tighten the
valve (1) or (1A) and release the lever or the pedal.
- Repeat this operation a few times until the oil is completely drained.
- Fill the reservoir (2) or (2A) with the new fluid.
- Pull and hold the lever (3), or press and hold the pedal (3A) so that the system
is under pressure; loosen the valve (1) or (1A) tighten the valve (1) or (1A)
always holding the lever pulled or the pedal pressed, then release.
- Top up the fluid level (2) or (2A) and repeat a few times the procedure de-
scribed in the line above until the system is completely full and the clear fluid
begins to come out without bubbles from the transparent hose.
- After changing the fluid, you will need to bleed air from the circuit.
H02298
L.9
Workshop Manual Ed. 07-2012