Reassembling The Front Wheel; Speed Sensor (Te) - Husqvarna 2013 TC 250R Workshop Manual

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
4
2
1
H02632
CHASSIS AND WHEELS
TXC 250R - 310R 2013 I.E. USA

Reassembling the front wheel

Fit the L.H. spacer (1) on the wheel hub.
Fit the wheel between the fork legs so as to set the brake disc into the calliper.
Fit the wheel axle (2) from the R.H. side, after greasing it and push it fully
home against the L.H. fork leg; during this operation, the wheel should be
turned.
Tighten the screw (3) on the fork L.H. side but DO NOT lock it. Now, pump for a
while, pushing the handlebar downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (4) on the R.H. leg (10.4 Nm, 1.05 Kgm, 7.7
ft/lb), the screw (3) on the L.H. side (51.45 Nm, 5.25 Kgm, 38 ft/lb), the screws
H10170
(1) on the L.H. leg ( 10.4 Nm, 1.05 Kgm, 7.7 ft-lb).
4
3
H10171

Speed sensor (TE)

Check the gap "B" between magnet (6) on brake disc and sensor (7) on brake
calliper.
After reassembly, pull the brake control lever until the pads are
against the brake disc.
Y.7
Workshop Manual Ed. 07-2012