Gear Shift And Kick Start Pedal Installation - Husqvarna 2013 TC 250R Workshop Manual

ENGINE REASSEMBLY
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Gear shift and kick start pedal installation

Install the gear shift pedal (1) and tighten the screw (2) using an 8 mm wrench
(8 Nm, 0.8 Kgm, 5.8 ft/lb).
Check the pedal (1) for damage.
Refit the kick start pedal (3) and tighten the screw (4) using a 12 mm wrench
(25 Nm, 2.5 Kgm, 18.44 ft/lb + Loctite 272). Make sure that the pedal does not
foul the cover.
3
4
H11357
Workshop Manual Ed. 07-2012
H.55