Piston Ring Installation; Piston And Cylinder Installation - Husqvarna 2013 TC 250R Workshop Manual

ENGINE REASSEMBLY
TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA

Piston ring installation

Fit the piston rings as shown in the diagram. If the piston ring is marked on one
side, that side must be facing up.
A= Compression ring
C= Oil control ring
*C1= Top oil rail end gap position
*C1= Oil rail spacer end gap position
*C1= Bottom oil rail end gap position

Piston and cylinder installation

Remove the rubber protection (1).
Install a new cylinder foot gasket (2).
Assemble piston (3) to connecting rod (4) (lubricate with engine oil) and fit the
piston pin retaining rings (5).
Make sure the arrow mark on the piston is pointing to the front end.
Make sure that the locating pins (6) are in place.
H11123
Workshop Manual Ed. 07-2012
H.41