Operation Manual For "Husqvarna Service Tool" For Injection Fuel Feeding System - Husqvarna 2013 TC 250R Workshop Manual

Husqvarna motorcycles 2013 te 250r; 2013 te 310r; 2013 te 310r usa; 2013 tc 250r; 2013 tc 250r usa; 2013 txc 250r usa; 2013 txc 310r usa
Table of Contents

Advertisement

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
5
4
B
C
Workshop Manual Ed. 07-2012
FUEL INJECTION SYSTEM
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Operation Manual for "HUSQVARNA SERVICE TOOL" for injection fuel
6
feeding system
3
The injection fuel feeding system does not require scheduled maintenance.
The "HUSQVARNA SERVICE TOOL" part no. 8000 H3898 lets you test system
components in the event of a malfunction.
The "HUSQVARNA SERVICE TOOL" is composed of:
1) "Diagnostic Tool" Software CD-ROM, including User Guide (PDF), Operation
1
Manual (PDF);
-
User Guide hard-copy;
-
Operation Manual hard-copy;
2) Diagnosis module part no. 8000H3902
2
3) Do not use
4) Module-PC USB cable part no. 8000 H3903
5) Diagnostic cable part no. 8000 H5153
H02374
6) Battery clamps cable part no. 8000 H5952
After installing the Diagnostic Tool Software according to the instructions
provided in the User Guide, proceed as follows:
-
Remove the saddle and disconnect the fuel pump connector;
-
Slip off the cap (B) of the ECU interface connector (C);
-
Connect the Kit cable (5) to the connector (C);
-
Connect the USB cable (4) to the PC;
-
Connect the cable (5) to the battery clamps cable (6);
-
Connect the clamps to the battery according to the polarity;
-
Start the "Diagnostic Tool" software you have installed and perform the
required tests.
H10166
1 -
2 -
3 -
4 -
5 -
6 -
7 -
For fuel pump and relay inspections, see relevant paragraphs.
This diagnostic software can check the following injection param-
eters:
AIR TEMPERATURE (air temperature in the intake manifold);
WATER TEMPERATURE (engine coolant temperature);
AIR PRESSURE (atmospheric pressure in current location and at current
altitude);
THROTTLE POSITION (throttle opening rate);
GEAR SHIFT POSITION (currently selected gear shift position);
INJECTOR (fuel injection pulse width);
IGNITION COIL (device that stores energy in the reel and discharges it to
the spark plug);
S.4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents