TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
TC 250R 2013 - TC 250R 2013 I.E. USA
5
6
8
9
10
12
11
7
11
ENGINE REASSEMBLY
TXC 250R - 310R 2013 I.E. USA
Refit the rotor (5). Hold the rotor (5) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (6) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
Before installing the starter motor (7), check for free (clockwise) rotation of the
freewheel (4) while holding the rotor (5) steady.
7
H02248
Assemble the starter motor (7).
On assembly, check the gasket (8) for damage and replace it if
needed. Make sure to position it correctly with the gasket hole (9)
matching the hole (10) in the starter motor flange.
H11052
Fit the starter motor (7) into place.
Tighten the bevel drive screws (11) using a 4 mm Allen wrench (6 Nm - 0.6Kgm
- 4.43 ft/lb).
Tighten the screws (12) (12a) using a 4 mm Allen wrench (6 Nm - 0.6Kgm - 4.43
ft/lb).
12=L= 25 mm
12a=L=30 mm
12a
H11053
H.39
Workshop Manual Ed. 07-2012