Husqvarna 2013 TC 250R Workshop Manual page 220

TE 250R - 310R 2013 I.E. / TE 310R 2013 I.E. USA
Workshop Manual Ed. 07-2012
FRONT SUSPENSION
TC 250R 2013 - TC 250R 2013 I.E. USA
TXC 250R - 310R 2013 I.E. USA
Push down the inner tube.
Slip the tool shown in the figure between wheel axle carrier and cartridge nut.
Insert the rebound adjuster rod into the piston rod and tighten the adjuster screw.
Be careful not to hurt your fingers.
H06852
Tighten the adjuster screw all the way in.
Make sure that there is some play between the bottom edge of the adjuster screw
and the upper edge of the nut.
H06853
Tighten nut and adjuster to 28 Nm (20.6 ft/lb) using a wrench.
H06854
I.16