Sensor Settings - AMX Modero NXD-500i Operation/Reference Manual

Setup Pages and Descriptions
Password Settings Page (Cont.)
In Panel Password
Change:

Sensor Settings

The Sensor Settings page (FIG. 57) allows adjustment of the Light and Motion Sensor parameters on a Modero
touch panel.
FIG. 57 Sensor Settings page
The elements of the Sensor Settings page are described in the table below:
Sensor Settings Page
Back:
Wired icon:
Connection Status icon: This visual display of the connection status allows the user to have a current visual
Light:
Light Sensor:
64
Accesses the alphanumeric values associated to particular password sets.
The PASSWORD 1, 2, 3, 4 and 5 (protected) buttons open a keyboard to enter alpha-
numeric values associated to the selected password group.
Note: Clearing Password #5 removes the need to enter a password before accessing
the Protected Setup page.
Saves the changes and returns you to the previously active touch panel page.
The icon to the left of the Connection Status Icon displays that the current connection
to the Master is Wired (image of three networked computers).
update of the panel's connection status regardless of the page that is currently active.
• A Lock only appears on the icon if the panel has established a connection with a
currently secured target Master requiring a username and password.
The Light bargraph displays a vertical bargraph indicating the light level detected by
the on-board photo-sensor.
Allows the user to review the Modero panel light sensor port and channel settings:
• The Sensor Level field indicates the level used to report the light sensor level back
to the NetLinx Master (set in TPD4) (read-only).
• The Sensor Level Port field indicates the port used to report the light sensor level
back to the NetLinx Master (set in TPD4) (read-only).
• The Sensor Channel field indicates the level used to report the sensor channel
back to the NetLinx Master (set in TPD4). It is On when below the Light Sensor
threshold level (read-only).
• The Sensor Channel Port field indicates the port used to report the sensor
channel back to the NetLinx Master (set in TPD4) (read-only).
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom