Call Management Using Headsets - AT&T Synapse User Manual

Call Management Using Headsets

You can use a corded headset, a Cordless Headset, or a combination of the two with the Deskset.
You can register an optional TL7600 Cordless Headset directly to your Synapse Deskset. There are no wires or cords
except for the power cord to the Headset charger. If you use another brand of cordless headset, you will have a more
complex setup. To learn more about the AT&T TL7600 Cordless Headset, visit our web site at
www.telephones.att.com/smb
To use a Headset:
Figure 318. Headset
Call Management
Synapse User's Guide
1 (888) 916-2007
or call
From Idle mode or during a call, press HEADSET, as shown in Figure 318.
If you have a headset connected to the jack on the bottom of the Deskset
and turned on, then that headset becomes active.
You cannot use the Deskset HEADSET key to control the audio of headsets
connected to the handset jack on the side of the Deskset.
If you have a AT&T TL7600 Cordless Headset registered to the Deskset,
then the Cordless Headset becomes active.
If you have both types of headsets installed, the headset connected to the
jack on the bottom of the Deskset becomes active. If you turn off or
unplug the headset connected to the jack on the bottom of the Deskset,
then the AT&T TL7600 Cordless Headset becomes active.
To return audio to the Deskset (speakerphone or corded handset), press
HEADSET.
230
1 (888) 883-2474
. In Canada, dial .