AT&T Synapse User Manual page 245

To reintroduce a Deskset into the system: (Continued)
3. Perform a complete factory reset to return to the
values set at the factory. Insert a pen or the end of a
paper clip into the reset switch, located on the
underside of the Deskset, as shown in Figure 329.
Hold until Restoring to Factory Defaults appears
on the screen (approximately 5 seconds). After the
Deskset restarts, it will rejoin the system. The Deskset
will be given the lowest available extension number,
which may be different than its previously assigned
extension number.
4. If you backed up the Deskset settings in Step 2,
restore your settings.
a. Log onto the WebUI as the Administrator at the
PC where you stored the back up file.
b. Click Device Management, then click Back up/Restore.
Under Back up Deskset Settings, select the Deskset's newly assigned extension number from the drop-down list.
c.
d. Select the back up file.
e. Click Restore Extension.
5. Synapse Desksets with static IP addresses need to have new addresses assigned if the Deskset IP addresses are to be used
for logging into the WebUI. At the Deskset, press MENU –> 3 –> 4 –> 2 to set the IP address.
Troubleshooting
Synapse User's Guide
245
Figure 329. Deskset Reset Button