The power wheelchair can be retrofit with a lap belt. This
may only be used as a safety belt while driving the power
wheelchair.
Applying the lap belt
1. Push the two halves of the buckle together so they en-
gage. The belt buckle must snap in place with an audi-
ble click.
2. Pull on the belt to ensure that it is locked. The lap belt
should not be too tight on the body. Objects caught
under the belt can cause painful pressure sores.
Releasing the lap belt
1. Press the red release button. The buckle opens.
Adjusting the Belt Length
The belt length can be adjusted on both sides.
1. Position both buckle halves in the middle of the body.
2. After positioning the buckle halves at a right angle in
relation to the belt, their position can be varied. The
excess belt length is taken up by the plastic sliders.
Skippi plus
Fig. 46
Applying the lap belt
7.10 Additional options
Joystick accessories (e.g. Tetra fork; STICK S80; Soft-
ball; Golfball)
Headrest mounting kit (e.g. NUTEC; Mygo; Squiggles):
For mounting to the back tube
Control panel guard: Metal guard for impact protection
Bumper bar
Manual horn
Pennant
Tray
Tray centre control unit (only as custom fabrication)
Accessories
1
Ottobock | 73