Adapter Cable For Piko Button; Additional Options; Control Panel Holder; Adjusting The Control Panel Position - Otto Bock C1000 DS Instructions For Use Manual

8.14.6 Adapter cable for Piko button

INFORMATION
For additional information on the user-specific adjustment of this function: see inside front cover.
The power wheelchair may be equipped with an optional adapter cable and Piko buttons.
• The adapter cable makes it possible to connect Piko buttons for control functions.
• The Piko buttons, which are connected in pairs, are used to control power seat functions as well as other func­
tions. These functions are specified when the power wheelchair is ordered.
• If e.g. the chin control is connected, the chin control moves to the active position when a button is pressed.
The chin control moves back to the passive position when the second button is pressed.
Available functions

8.15 Additional options

8.15.1 Control panel holder

Swing-away control panel holder
The control panel holder makes it possible to drive the power wheelchair under a table or closer to an object.
The control panel holder can be rotated up to the armrest. In addition, the control panel can be removed upwards
from the control panel holder.
46
Height-adjustable control panel holder
The height-adjustable control panel holder allows for height adjustment of the control panel.
47

8.15.1.1 Adjusting the control panel position

INFORMATION
By default, the control panel is mounted on the side specified in the order. It can also be mounted on the other
side of the power wheelchair later on if the user so desires. Please contact the qualified personnel who delivered
the product to you.
C1000 DS
Swinging away the control panel holder
1) Apply slight pressure to push the control panel
holder to the side.
→ The pivot element is unlocked.
2) Swing the control panel holder away to the side.
INFORMATION: The pivot element locks in
place again when the holder is rotated back to
the original position.
Adjusting the height
1) Loosen the mounting screws.
2) Adjust the height of the control panel holder.
3) Tighten the mounting screws.
Use
59