Battery Pack - Otto Bock Skippi plus Instructions For Use Manual

teries at the factory. The batteries are located in 2 battery
packs below the seat of the power wheelchair (Fig. 34).
To display the battery capacity on the control panel, see
chapter 6.3.5.
Fig. 34

Battery pack

Due to the sealed design, the GEL technology used fulfills
the latest safety and environmental compatibility provisions.
The battery packs are integrated in separate battery packs
for additional safety and improved handling. The batteries
were designed for high cycle stability and are particularly
well suited to traction operation due to the special lead
plates.
Skippi plus
Please contact your authorised specialist dealer to replace
or dispose of the batteries (batteries in the battery pack).
The batteries must be replaced as complete units (battery
packs).
Proceed as follows to remove/install the battery packs:
1. Release the seat lock by pulling on the release strap and
folding the locking bar back at the same time (Fig. 10).
2. The battery packs are now accessible Remove the bat-
tery packs (Fig. 11).
3. Place the new battery packs back into the drive unit.
Ensure that the red arrows on the battery packs point
in the driving direction and that the plug contacts (Fig.
35) engage with the battery contacts.
4. The locking lever should be engaged again to prevent
the battery packs from falling out (Fig. 10).
Operation
Ottobock | 55