Otto Bock Skippi plus Instructions For Use Manual page 18

Safety
NOTICE
Interference from electromagnetic fields. The power
wheelchair has been tested according to EMC regulations.
The following particularities must be observed during op-
eration:
The driving characteristics of the power wheelchair may
be affected by electromagnetic fields (mobile phones or
other radiating devices). All mobile devices must be turned
off while driving.
The power wheelchair may generate electromagnetic
fields that can cause interference with other devices.
Therefore the controls should be switched off when no
function is required.
INFORMATION
Road traffic regulations must be observed when driving in
road traffic.
INFORMATION
For the personal safety of the user, wearing the lap belt at
all times is always recommended. The lap belt helps to
stabilise the person sitting in the power wheelchair.
18 Ottobock
|
INFORMATION
Each time you switch on the control unit, it will return to the
previously selected speed level. If desired, the starting
speed level can be specified in the parameter settings.
These settings may only be made by personnel that have
been authorised and trained by Ottobock.
INFORMATION
The power wheelchair will accelerate or decelerate if the
driving mode is changed while driving.
INFORMATION
The control unit of the power wheelchair is protected ac-
cording to protection class IP 54 and the push button mod-
ule according to protection class IP 64. Both can be used
accordingly in bad weather (e. g. rain). The control unit /
push button module is approved for indoor and outdoor
operation and meets the requirements regarding climate
and splash water.
Skippi plus