Removing The Control Panel; Removal For A Swing-Away Control Panel Holder - Otto Bock Skippi plus Instructions For Use Manual

Operation

Removing the Control Panel

The control panel can be removed simply by pulling on it
(Fig. 20).
For a swing-away control panel (see chapter 7.7.1), the
control panel is removed from the control panel bracket ball
coupling (Fig. 21).
Fig. 20 Removing the control panel
38 Ottobock
|
Fig. 21

Removal for a swing-away control panel holder

Adapting the control panel to the arm length
The control panel is attached to a rail which is located be-
neath the armrest.
1. Use a size 3 Allen wrench to loosen all three set screws
on the bottom of the armrest.
2. Move the control panel with the control panel holder or
replacement tube forward or backwards along the at-
tachment rail to the desired position.
3. Retighten all set screws.
INFORMATION
If the control panel rail is too long, the protruding part can
simply be cut off.
Skippi plus