Additional Options; Control Panel Holder; Adjusting The Control Panel Position - Otto Bock C2000 Instructions For Use Manual

Use
• The adapter cable makes it possible to connect Piko buttons for control functions.
• The connected Piko button can be used to control power seat functions as well as other functions. These func­
tions are specified when the power wheelchair is ordered.
• For example, if the power back support angle adjustment is activated, the back support tilts back as long as the
button is pressed the first time the button is activated. Activating this function again causes the back support to
tilt forward as long as the button is depressed.

8.16 Additional options

8.16.1 Control panel holder

Swing-away control panel holder
The control panel holder makes it possible to drive the power wheelchair under a table or closer to an object.
The control panel holder can be rotated up to the armrest. In addition, the control panel can be removed upwards
from the control panel holder.
41
Height-adjustable control panel holder
The height-adjustable control panel holder allows for height adjustment of the control panel.
42

8.16.1.1 Adjusting the control panel position

INFORMATION
By default, the control panel is mounted on the side specified in the order. It can also be mounted on the other
side of the power wheelchair later on if the user so desires. Please contact the qualified personnel who delivered
the product to you.
The depth position of the control panel is subsequently adjustable.
56
Swinging away the control panel holder
1) Apply slight pressure to push the control panel
holder to the side.
→ The pivot element is unlocked.
2) Swing the control panel holder away to the side.
INFORMATION: The pivot element locks in
place again when the holder is rotated back to
the original position.
Adjusting the height
1) Loosen the mounting screws.
2) Adjust the height of the control panel holder.
3) Tighten the mounting screws.
C2000