Disassembling The Power Wheelchair - Otto Bock Skippi plus Instructions For Use Manual

Transportation and Storage
CAUTION
Risk of injury due to insufficient restraints. During trans-
port in another vehicle, the power wheelchair must be se-
cured sufficiently with tensioning straps.
Ensure that the wheelchair is fully secured with tensioning
straps during transportation in a motor vehicle for the disa-
bled. Four eyelets are provided on the frame of the Skippi
plus in order to attach straps (Fig. 3/4).
Before transporting the power wheelchair, switch the control
unit off and engage the wheel lock (see chapter 6.4).
Fig. 5 Rear eyebolts, front eyebolts
28 Ottobock
|
5.1.1 Required Accessories
To use the power wheelchair as a seat in a wheelchair ac-
cessible vehicle, additional accessories have to be mounted
(491S00=SK024 Anchor Point Kit).
The qualified personnel which fit the wheelchair can provide
more information.
5.2

Disassembling the power wheelchair

NOTICE
Risk of cable damage. Take care to ensure that cables
are not pinched when the wheelchair is disassembled/as-
sembled.
INFORMATION
The frame and drive unit must not be separated if the
Skippi plus is equipped with one of the following electric
options:
- Seat height adjustment
- Electric seat tilt
- Electric back angle adjustment
In this case, skip steps no. 7/8 below.
Skippi plus