Operation
6.1.2 Side Panel with Armrest
The side panels can be removed by loosening the thumb
screws and lifting the side panels. If the control panel is at-
tached to the armrest, the side panel must be removed to-
gether with the control panel and carefully deposited on the
ground or on the wheelchair seat.
The thumb screws are located at the lower end of the arm-
rest holders (see arrow, fig. 7).
Fig. 7
Removing the side panel
After remounting the side panel, do not forget to firmly
retighten the thumb screw.
26 | Ottobock
The side panels must be inserted into the armrest
INFORMATION
holder up to the height of the lowest receiver tube's bore
hole at least.
Adjusting the armrest height: After loosening the Allen
head screw with a size 3 Allen key (see fig. 8, left), the height
of the arm rest can be adjusted.
Firmly re-tighten the screws after making adjustments.
Adapting the armrest to the forearm length: Slide the
armrest forwards or backwards and engage in the slot cor-
responding to the desired position (see fig. 8, right).
Tighten the screws again after making the adjustment.
Fig. 8
Adjusting the side panels
B400