Rear Shock Absorber; Rear Fork - KYMCO VENOX 250 Service Manual

13
. REAR WHEEL/BRAKE/SUSPENSION

REAR SHOCK ABSORBER

REMOVAL/INSTALLATION
Remove the shock absorber upper mount
nuts and washers and then press down the
motorcycle to pull out the shock absorbers.
Remove the shock absorber lower mount
bolts to remove the rear shock absorbers.
INSTALLATION
The installation sequence is the reverse of
removal.
Torque:Upper 0.8～1.2kg-m
Lower 3.0～4.0kg-m

REAR FORK

REMOVAL
Remove the rear wheel.
Remove the rear shock absorbers.
Remove the rear fork pivot nut to remove
the pivot and rear fork.
Remove the drive chain slider and check for
wear or damage.
When replacing the rear fork pivot
bushings, apply grease to the pivot
bushing.
INSTALLATION
Install the rear fork in the reverse order of
removal.
Tighten the rear fork pivot nut.
Torque: 6.0～8.0kg-m
After the rear fork is installed, install the
following parts:
Rear shock absorbers
Rear wheel
Drive chain cover
13-9
Upper Mount
Lower Mount Nut
Chain Slider
Rear Fork
VENOX 250
Rear Fork Pivot Nut
Pivot Bushing
Rear Fork Pivot