10
.TRANSMISSION SYSTEM
BEARING REPLACEMENT
Remove the main shaft and countershaft
bearings from the main shaft and
countershaft using a bearing remover.
Special
Bearing Remover
Drive the new bearing into the shaft using a
bearing driver.
• The flange of the oil seal should fix in
the groove of the upper crankcase.
• Drive the bearing squarely.
Special
Bearing Remover
MAIN SHAFT/COUNTERSHAFT
INSTALLATION
Apply engine oil to the main
shaft/countershaft before installation.
• Confirm each gear for smooth drive.
Align the hole on the collar with the hole
on the each shaft.
Hole
VENOX
250
Bearing Remover
Bearing Driver
10-10