KYMCO VENOX 250 Service Manual page 141

12
. FRONT WHEEL/SUSPENSION/STEERING
Remove the four upper fork bridge bolts to
remove the handlebar.
INSTALLATION
Place the handlebar on the upper fork
bridge seat.
Install the upper fork bridge set plates onto
the handlebar. First tighten the front bolts
and then the rear bolts.
Torque: 1.7～2.1kg-m
When installing the right and left handlebar
switch housings. Tighten the two switch
housing screws.
When installing the master cylinder and
clutch lever holders, align the tab on the
holder with the hole in the handlebar with
the holder "UP" mark facing up.
First tighten the upper bolt and then the
lower bolt.
12-5
Upper Fork Bridge
Bolts
VENOX
Upper Fork Bridge Seat
250