KYMCO VENOX 250 Service Manual page 170

14
. HYDRAULIC BRAKE
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the pistons and oil
seals. Lubricate the brake caliper cylinder
inside wall with brake fluid.
Install the oil seals and then install the
brake caliper pistons with the grooved side
facing out.
Install the piston with its outer end
protruding 3～5mm beyond the brake
caliper.
Wipe off excessive brake fluid with a clean
towel. Apply silicon grease to the brake
caliper seat pin and caliper inside.
Install the brake caliper seat.
INSTALLATION
Install the brake caliper onto the right front
fork and tighten the bolts.
Torque: 2.4～3.0kg-m
Connect the brake fluid tube to the brake
caliper and tighten the fluid tube bolt.
Add the recommended brake fluid into the
brake reservoir and bleed air from the brake
system.
VENOX 250
14-10