Front Shock Absorber - KYMCO Dink-R 150 Manual

13
.
STEERING HANDLEBAR/FRONT WHEEL/
FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the pistons and oil seals.
Lubricate the brake caliper cylinder inside wall
with brake fluid.
Install the brake caliper piston with grooved side
facing out.
＊
Install the piston with its outer end
protruding 3～5mm beyond the brake
caliper cylinder.
Wipe off excessive brake fluid with a clean shop
towel. Apply silicon grease to the brake caliper
seat pin and caliper inside.
Install the brake caliper seat.
INSTALLATION
Install the brake caliper and tighten the two bolts.
Torque: 2.9～3.5kg-m
Connect the brake fluid tube to the brake caliper
and tighten the fluid tube bolt.
Torque: 3.0～4.0kg-m
Fill the brake reservoir with recommended brake
fluid and bleed air from the brake system.

FRONT SHOCK ABSORBER

REMOVAL
Remove the front cover.
Remove the front wheel.
Remove the front shock absorber upper mount
bolts.
Loosen the lower mount bolts to remove the front
shock absorbers.
13-13
Dink-R 150
Fixed-Reed
Caliper Bolts
Mount Bolt
Brake Pads