Cooling System - KYMCO VENOX 250 Service Manual

2
. INSPECTION/ADJUSTMENT

COOLING SYSTEM

Place the motorcycle on its main stand
on level ground for coolant level check.
Check if the coolant level is between the
upper and lower limits on the reserve tank.
If the coolant level is too low, it means that
there are abnormal conditions.
First fill the reserve tank with coolant to the
upper level line.
Start the engine and allow the cooling
fan to run. Then, stop the engine.
Check the coolant level in the reserve
tank and fill to the upper level line if the
level is under the lower level line.
Coolant concentrate specified
density:30%(cold area 50%).
Inspect the telltale hole for signs of
mechanical seal coolant leakage.
If the mechanical seal is leaking, replace the
water pump assy.
Remove the reserve tank cap and fill to the
upper level line with distilled water.
Press down the reserve tank cap.
Remove the drain bolt to drain the coolant.
2-11
Upper Limit
Lower Limit
Telltale Hole
Reserve Tank Cap
Drain Bolt
VENOX 250