Clutch Switch - KYMCO VENOX 250 Service Manual

18
. LIGHTS/INSTRUMENT/SWITCHES/HORN
INSPECTION
Check the fuel unit O-ring for wear,
damage or deformation. Replace if
necessary.
Measure the continuity between the fuel
unit wire terminals with the float at the
upper (Full) and lower (Empty) positions.
Resistances: Upper (Full): No continuity
Lower (Empty): Continuity
Connect the fuel unit wire coupler to the
wire harness and turn the ignition switch
ON.
Empty
Check the fuel indicator for lighting.
If the fuel indicator isn't light, the fuel
indicator is faulty and replace it with a new
one.
INSTALLATION
Install the fuel unit in the reverse of
removal.
Check for fuel leakage after installation.
Full

Clutch Switch

CLUTCH SWITCH
Disconnect the clutch switch wire coupler.
The clutch switch is as shown.
Check for continuity between the terminal
of the clutch switch.
Clutch lever ( ) probe ( ) probe
No Apply No continuity
Apply Continuity
18-8