Oil Pump - KYMCO VENOX 250 Service Manual

3
. LUBRICATION SYSTEM

OIL PUMP

REMOVAL
1. Disconnect the clutch cable.
2. Remove the right crankcase cover bolts
and right crankcase cover.
When installing, make sure to use a new
right crankcase cover gasket.
Remove the bolt attaching the starter gear.
Remove the reduction gear, shaft and collar.
Remove the four clutch lifter bolts.
Remove the clutch lifter and four tension
springs.
Remove the clutch filter rotor lock nut and
then remove the washer and clutch filter
rotor.
Remove the clutch center, clutch friction
disks and plates.
Remove the thrust washer, clutch outer and
outer guide.
During installation, install the washer
with the mark facing up.
Remove the three oil pump gear cover bolts
and oil pump sprocket nut to oil pump gear
cover.
Torque:
Oil pump sprocket nut:1.8～2.3kg-m
Disconnect the oil pump driven gear and
chain.
Clutch Cable
Bolts
Bolts
Clutch
Lifter
Nut
Drive Gear
Oil Pump Driven Gear
VENOX 250
Right Crankcase Cover
Bolts
Reduction
Gear
Bolts
3-4