Engine Oil/Oil Filter - KYMCO VENOX 250 Service Manual

3
. LUBRICATION SYSTEM

ENGINE OIL/OIL FILTER

OIL LEVEL
• Place the motorcycle upright on level
ground for engine oil level check.
• Run the engine for 2～3 minutes and
check the oil level after the engine is
stopped for 2～3 minutes.
If the level is near the lower limit, fill to the
upper limit with the specified engine oil.
OIL CHANGE
The engine oil will drain more easily
while the engine is warm.
Remove the drain bolt to drain the engine oil
thoroughly.
Check the drain bolt washer for damage or
deformation and replace with a new one if
necessary.
Torque: Oil drain 2.0～3.0kg-m
Remove the oil filter screen cap and then
remove the oil filter screen and spring.
Check the filter screen cap O-ring for
damage or deformation and replace if
necessary.
Install the oil filter screen, spring and filter
screen cap.
Torque: 2.0～3.0kg-m
Do not install the oil filter screen upside
down.
Oil Capacity:
At disassembly: 2.5 liter
At change without oil filter: 2.2 liter
At change with oil filter: 2.0 liter
Check for oil leaks and then start the engine
and let it idle for few minutes.
Stop the engine and recheck the oil level.
3-3
Upper Limit
Lower Limit
Drain Bolt
Oil Filter Screen Cap
VENOX 250