17. IGNITION SYSTEM PEOPLE/PEOPLE S 250 IGNITION SYSTEM LAYOUT Ignition Switch Ignition Unit Ignition Coil A.C. Generator Pulser Coil IGNITION CIRCUIT IGNITION UNIT 17-1...
17. IGNITION SYSTEM PEOPLE/PEOPLE S 250 SERVICE INFORMATION GENERAL INSTRUCTIONS • Check the ignition system according to the sequence specified in the Troubleshooting. ( 1-28) • The ignition system adopts ignition unit and the ignition timing cannot be adjusted. • If the timing is incorrect, inspect the ignition unit and A.C. generator and replace any faulty parts.
17. IGNITION SYSTEM PEOPLE/PEOPLE S 250 Ignition Coil SPARK PLUG For spark plug inspection and adjustment, refer to page 3-5. IGNITION COIL INSPECTION Remove the seat and met-in box. ( 2-6) Remove the ignition coil Ignition Coil Primary Coil IGNITION COIL CONTINUITY TEST Inspect the continuity of the ignition coil, primary coil and secondary coil.
17. IGNITION SYSTEM PEOPLE/PEOPLE S 250 A .C. GENERATOR INSPECTION EXCITER COIL/PULSER COIL INSPECTION * This test is performed with the stator installed in the engine. Remove the seat and met-in box. ( 2-6) Disconnect the A.C. generator connector. Measure the exciter coil resistance between the black/white wire terminal and ground.
Page 6
17. IGNITION SYSTEM PEOPLE/PEOPLE S 250 * • Due to the semiconductor in circuit, it is necessary to use a specified tester for accurate testing. Use of an improper tester in an improper range may give false readings. • In this table, “Needle swings then returns”...