Setting The Format Of Data To Be Received; Setting The Command Mode - GRAPHTEC CE5000-60 User Manual

4.18 Setting the Format of Data to be Received

Before data is sent from the computer, the format (command mode) of data sent by the application soft-
ware must be checked. The cutting plotter accepts two data formats (command modes): GP-GL (Graphtec)
and HP-GL commands. Set the command mode to suit the application used.
M O V E T O R . M A R K
F E E D
A U T O P R E F E E D
T A N G E N T I A L
A U T O R E G . M A R K
C L E A R B U F F E R
A X I S A L I G N M E N T
D I S T A N C E A D J U S T
P A G E L E N G T H
P L O T A R E A
E X P A N D
R O T A T E
M I R R O R
C O P Y
S O R T
R S - 2 3 2 C
C O M M A N D
B L A D E W E A R S E T U P
P E N U P / D O W N
T E S T M O D E
P E N U P S P E E D
O F F S E T F O R C E
O F F S E T A N G L E
S T E P P A S S
I N I T . D O W N F O R C E
L E N G T H U N I T

■Setting the Command Mode

1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
C O M M A N D
3
Step
Press the (ENTER) key to display the command-setting menu.
C O M M A N D G P - G L
4
Step
Press the or key to select "GP-GL" or "HP-GL," and then press the
(ENTER) key to confirm. To cancel the selection, press the
(PREV.) key.
5
Step
If "GP-GL" is selected, set the STEP SIZE. If "HP-GL" is selected, set the ORIGIN
POINT. If a command different from that set previously is selected, the PAUSE
mode is automatically canceled after STEP SIZE (GP-GL) or ORIGIN POINT (HP-
GL) is set.
(PREV.) key until the following menu is displayed.
4 – 36
(NEXT) or