GRAPHTEC CE5000-60 User Manual page 60

If "inch" is the unit displayed, select from among "OFF," "0.25," "0.5," "0.75," "1.0," "1.5" and "STD."
6
Step
Press the (PAUSE) key to cancel PAUSE mode.
Setting the Registration-Mark Origin Point
If the registration-mark origin point is not set, it will be positioned as shown in the figures below. This func-
tion should be set when it is required to move the origin point from this position.
M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
Registration-mark pattern 1
New origin
position
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
A U T O R E G . M A R K
3
Step
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then
press the (NEXT) or
M A R K O F F S E T
4
Step
Press the (ENTER) key to display the X-axis registration-mark origin input set-
ting.
O F S T X = 0 0 0 . 0
5
Step
Use the or key to move the cursor to the digit to be entered, use the
key to increase or decrease the values (or display/don't display "-" for the
space to the right of "="), and then press the
axis origin input setting is then displayed and should be set in the same way. To
cancel the selection(s), press the
Registration-mark pattern 2
Origin
Y
(PREV.) key until the following menu is displayed.
(PREV.) key until the following menu is displayed.
(NEXT) or
4 – 16
New origin
position
Origin
Y
(ENTER) key to confirm. The Y-
(PREV.) key.
X
Y
or