Table of Contents
Advertisement
Chapter 4 Convenient Functions
4.1
Cutting Roll Media
To use roll media, load media to the roll media stocker. Roll media of standard media width can be used.
•
Depending on the type of media (especially with high transparency), the media cannot be set because CE
LITE-50 cannot detect the leading edge /width /position of the media. In this case, disable the Media width
detection.
•
Depending on the type of media, the center of the media may be lifted up because the push rollers cannot
hold down the media sufficiently. In this case, move the Media holding rollers (movable) to the position where
the media is lifted up. When the media is load flat, move them to the right push roller.
•
Move the Media holding rollers (movable) after raising the Media set levers.
•
Limp or too much thin media cannot be cut.
For more information on the media width detection, refer to "5.7 Setting the Media Width Detection."
Supported widths:
Mountable diameters: 2 inch media core Maximum diameter of 150 mm, Minimum diameter of 52.8 mm
Mountable weight:
Assembling the Roll Media Stocker
Set the roll media stocker along the roll media stocker guide rail on the bottom of the main unit. Pay attention to
the orientation of each part and set Part A on the left, Part C on the right, and Part B in a position that suits the
width of the roll media.
Roll Media Stocker Guide Rail
Set Part D to the groove on the edge of Part A, B, and C as shown in the figure below.
4-2
A4 - 20 inch (refer to "1.5 Media Size and Cutting Area")
3 inch media core Maximum diameter of 150 mm, Minimum diameter of 78.2 mm
2.5 kg or less
A
B
D
C
Advertisement
Table of Contents
