Cutting Demo - GRAPHTEC CE5000-60 User Manual

2
Step
Load an A4-size or larger medium.
3
Step
Press the (PAUSE) key to switch to PAUSE mode.
4
Step
Press the (NEXT) or
T E S T M O D E
5
Step
Press the (ENTER) key to display the test-mode submenu, and then press the
(PREV.) key until the following menu is displayed.
D U M P
6
Step
Press the (ENTER) key to switch to dump mode.
C H A R D U M P M O D E
7
Step
When data is sent to the cutting plotter in this mode, a dump list is printed out. To exit the dump mode, turn
on the power again.
CHECKPOINT
The dump list is printed out as ASCII character codes. Characters without codes
will be printed as small 2-digit figures. Output data for READ-type commands will
be output as dummy data, except for cutting-plotter status output.
The pen carriage begins moving as soon as this function is set. Keep your hands and
CAUTION
other objects away from the cutting plotter's moving parts.

■ Cutting Demo

This function cuts a cutting-demo pattern.
1
Step
Mount a plotting pen in the pen carriage, and set the conditions to suit the pen used (e.g., force, pen speed
settings) (see "3.3 Setting the Cutter-Pen Conditions").
CHECKPOINT Load the medium so that it passes over the media sensor.
2
Step
Load a film for cutting.
(PREV.) key until the following menu is displayed.
4 – 45
(NEXT) or