Reading The Auto Registration Marks - GRAPHTEC CE5000-60 User Manual

4.2

Reading the Auto Registration Marks

M O V E T O R . M A R K
F E E D
A U T O P R E F E E D
T A N G E N T I A L
A U T O R E G . M A R K
C L E A R B U F F E R
A X I S A L I G N M E N T
D I S T A N C E A D J U S T
P A G E L E N G T H
P L O T A R E A
E X P A N D
R O T A T E
M I R R O R
C O P Y
S O R T
R S - 2 3 2 C
C O M M A N D
B L A D E W E A R S E T U P
P E N U P / D O W N
T E S T M O D E
P E N U P S P E E D
O F F S E T F O R C E
O F F S E T A N G L E
S T E P P A S S
I N I T . D O W N F O R C E
L E N G T H U N I T
1
Step
When "2 POINT," "3 POINT," or "4 POINT" has been set (see "4.6 Auto-Registra-
tion-Mark-Reading Settings"), press the
mode and display the following menu.
M O V E T O R . M A R K
2
Step
Use the , ,
lower-right registration mark, and then press the
reads between points 1 and 2 (and also between points 1 and 3 for 3-point align-
ment or 4-point alignment), and the following is displayed.
X 0 0 3 0 8 . 9 0 0 3 0 8 . 9
CHECKPOINT
• If the registration-mark distance correction is set to
• The registration marks are read in accordance with the
3
Step
The distance between X-axis registration marks (points 1 and 2) read by the cut-
ting plotter is displayed on the left. Enter the actual distance on the right. Use the
or key to move the cursor to the digit to be entered, use the
to increase or decrease the values, and then press the
firm. For 3-point alignment or 4-point alignment, the distance between the Y-axis
registration marks (points 1 to 3) is also displayed and should be set in the same
way. To cancel the selection(s), press the
, and (POSITION) keys to move the cutter pen to the
"5 mm," "10 mm," "50 mm," or "STD." the alignment
input screen is not displayed.
registration-mark-detection movement distance setting.
(NEXT) or
4 – 3
(PAUSE) key to switch to PAUSE
(ENTER) key. The sensor
(ENTER) key to con-
(PREV.) key.
or key