Setting Wear-Rate Factors; Clearing The Total Distance (Wear Rate) - GRAPHTEC CE5000-60 User Manual

■ Setting Wear-Rate Factors

This sets factors corresponding to the differences in wear rates due to different materials and cutting con-
ditions.
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
B L A D E W E A R S E T U P
3
Step
Press the (ENTER) key to display the wear-rate setting submenu, and then press the
(PREV.) key until the following menu is displayed.
F A C T O R
4
Step
Press the (ENTER) key to display the wear-rate factor setting.
C O N D 1 1 . 0 0
5
Step
Use the or key to increase or decrease the setting-area number, and use the
increase or decrease the factor value. The factor can be set to between 0.10 and 1.00 in 0.10 intervals, and
between 1.00 and 2.50 in 0.25 intervals. Once the wear-rate factor is set, press the
confirm. To cancel the selection(s), press the
6
Step
Press the (PAUSE) key to cancel PAUSE mode.

■ Clearing the Total Distance (Wear Rate)

Always zero the total-distance display when a cutter blade has been replaced. This starts the total-distance
calculation from zero.
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
B L A D E W E A R S E T U P
(PREV.) key until the following menu is displayed.
(NEXT) or
(PREV.) key until the following menu is displayed.
4 – 40
(PREV.) key.
(NEXT) or
or key to
(ENTER) key to