Setting Tool (Cutter Blade Or Pen); Setting Offset - GRAPHTEC CE5000-60 User Manual

Ce5000 series cutting plotter
Hide thumbs Also See for CE5000-60:
Table of Contents

Advertisement

■ Setting TOOL (cutter blade or pen)

Set the type of pen (cutter blade) to be used.
1
Step
To display the cutter-pen conditions, either press the
mode, or when the media set lever is lowered and the buffer is in the empty (cleared) status.
2
Step
Select the setting area (condition number) to be set, and then press the
bol to the position shown below.
2
0 9 U + 1 1 4 3 0 2
3
Step
Press the
or
key to select "09U," "15U," "15B," or "PEN." Press the
the selection. If other conditions are to be set, press the
eter to be set.

■ Setting OFFSET

This setting adjusts the offset of the cutter blade to suit the blade type used. The tip of the blade mounted
in the cutter-pen plunger is not positioned at the center of the pen, so correction is required. This correction
is referred to as the OFFSET setting. The cutting plotter has been preset with OFFSET values for each cut-
ter-blade type. Selecting "09U," "15U," or "15B" for the PEN TYPE setting also sets the appropriate OFF-
SET, allowing fine adjustment within the range of ±5. When the "PEN" setting is selected, the OFFSET
cannot be set.
1
Step
Press the
(COND.) key in READY mode to display the cutter-pen conditions.
2
Step
Select the setting area (condition number) to be set, and then use the
bol to the position shown below.
2 0 9 U
+ 1 1 4 3 0 2
3
Step
Use the
or
key to select the value to be changed in the range of "-5" to "+5." Press the
(ENTER) key to confirm the selection. If other conditions are to be set, press the
the
symbol to the parameter to be set.
(COND.) key when the cutting plotter is in READY
or
key to move the
3 – 7
or
key to move the
(ENTER) key to confirm
symbol to the param-
or
key to move the
or
key to move
sym-
sym-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ce5000-120

Table of Contents