An Error Message Was Displayed - GRAPHTEC CE5000-60 User Manual

6.4

An Error Message Was Displayed

Symptom
CURRENT LIMIT or POSI-
TION ALARM is displayed.
The STATUS lamp flickers.
SPEED ERROR is displayed.
The STATUS lamp flickers.
Cause
The cutting conditions are not suitable for the
medium being cut.
Excessive load is causing the current to the
motor to exceed the rated value.
The pen carriage movement is being
obstructed.
The pen carriage was subjected to external
pressure during cutting.
Scraps of the medium in the moving parts are
impeding operation.
If this problem occurs frequently, contact your sales representative or nearest
Graphtec dealer.
The pen carriage was subjected to external
pressure after the power was turned on.
The internal speed control is faulty.
If this problem occurs frequently, contact your sales representative or nearest
Graphtec dealer.
6 – 5
Solution
Reduce the cutting speed.
Reduce the cutting force (see
"3.3 Setting the Cutter-Pen
Conditions").
Remove the obstruction and
turn the cutting plotter back
on.
Turn the cutting plotter off
and then back on again.