GRAPHTEC CE5000-60 User Manual page 77

If the data to be copied does not fit within the cutting/plotting area, the following message is displayed in
step 5.
C A N N O T C O P Y
Use the , , , and
with an area of sufficient size to fit the copied data.
CHECKPOINT
• If the initial cutting/plotting position was moved from the original origin, the new
• If the cutting plotter receives another set of data during the copying operation,
• If new data is sent to the cutting plotter more than 10 seconds after the initial cut-
• Copying will not be possible if data exceeding approx. 1.6 Mbytes is sent to the
(POSITION) keys to change the initial copying position or load a medium
origin will also apply during the copying operation. To prevent wasteful use of the
medium, the initial cutting/plotting position for the data should be as close as
possible to the origin.
the operation will not be properly completed because the initial data is cleared
during the operation. Do not send new data to the cutting plotter while copying is
in progress.
ting data is sent, the original data will be cleared from the internal memory.
cutting plotter, as the data will cause the buffer memory to overflow.
4 – 33