Loading The Medium; Loading A Roll Medium - GRAPHTEC CE5000-60 User Manual

4
Step
If no medium has been loaded, the message below appears on the display, prompting the loading of a
medium.
L O A D M E D I A ! !
If a medium has already been loaded, the current media setting is displayed as shown below.
R O L L 2 P R E S S E N T R
Select the media mode to suit the medium used. For instructions on loading media and selecting the media
mode, see "2.3 Loading the Medium."
2.3

Loading the Medium

Load the medium, aligning it with the right-hand grit roller when viewed from the front so that it registers
with the media sensor. Then, adjust the push-roller position to match the width of the medium. The cutting
plotter can use media in roll or sheet form. Load the desired medium type by following the appropriate
instructions.

■ Loading a Roll Medium

Load the roll medium onto the stand stock rollers.
Placing on the Stand
1
Step
Fit the stoppers to one of the stock rollers (loosen the screws on the stoppers first).
For the CE5000-60:
For the CE5000-120:
Stock roller
Stock roller
2 – 4
Stoppers
Stoppers