GRAPHTEC CE5000-60 User Manual page 62

8
Step
Measure the offset of the crosshairs in the X-axis, and enter the distance adjustment. Using the already
plotted crosshairs as the point of reference, enter the actual amount of the offset between these crosshairs
and the crosshairs that were plotted on top of them after the already plotted crosshairs were read by the
sensor. (For example, for the figure at the above right, since there is an offset in both the –X and –Y direc-
tions, enter the [X= –**mm] and [Y= –**mm] corrective values.)
A D J X =
9
Step
Move the cursor to the digit to be entered using the
decrease the values (or display/don't display "-" for the space to the right of "="), and then press the
(ENTER) key to confirm. If there is no offset, simply press the
adjustment input is then displayed and should be set in the same way. To cancel, press the
(PREV.) key.
10
Step
Press the (PAUSE) key to cancel PAUSE mode.
Adjusting the Registration-Mark Reading Sensor (2)
This adjusts the position of the sensor for reading the registration marks by plotting crosshairs and then
reading them. First set both cutter pen conditions 1 and 2 to the same pen. Crosshairs are first plotted
using conditions 1 and read by the sensor. A second set of adjustment crosshairs is plotted using condi-
tions 2. The difference between the two is input to adjust the position.
M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
0 . 0
1
Step
Load a medium into the cutting plotter.
2
Step
Set both cutter pen conditions 1 and 2 to the same "Pen" (refer to "3.3 Setting the
Cutter-Pen Conditions"), and load a pen in the cutting plotter.
3
Step
Press the (PAUSE) key to switch to PAUSE mode.
4
Step
Press the (NEXT) or
A U T O R E G . M A R K
or key, use the
(ENTER) key. The Y-axis distance-
Adjustment crosshairs
Distance adjustment Y
Distance
Crosshairs first plotted
adjustment X
(PREV.) key until the following menu is displayed.
4 – 18
or key to increase or
(NEXT) or
Y
X