GRAPHTEC CE5000-60 User Manual page 43

1
Step
Load the medium for test cutting on the cutting plotter.
2
Step
Use the , , , and
3
Step
Switch to READY mode, and then press the
4
Step
When test cutting has been completed, the pen carriage moves to the standby position and the following
menu is displayed.
P R E S S E N T E R K E Y
5
Step
Press the (ENTER) key to return the pen carriage to its previous position and to switch the cutting plot-
ter to READY mode.
6
Step
Adjust the CUTTER OFFSET value to suit the type and thickness of the medium being used, and fine-
adjust the finish of each corner. Set the FORCE so that only faint cutting lines remain on the base sheet
when the blade length is properly adjusted.
7
Step
Upon completion of fine adjustment, actual cutting data can be sent to the cutting plotter.
(POSITION) keys to move the pen carriage to the position for test cutting.
(TEST) key.
CUTTER
OFFSET
is too low
Increase
(by +1 to +5)
3 – 13
Correct CUTTER
CUTTER OFFSET
OFFSET is too high
setting Decrease
(by -1 to -5)