Roll Media - GRAPHTEC FC5100A-75 User Manual

Roll Media

To load sheet media:
• Lower the media set lever to raise the pinch rollers.
• Move the left pinch roller next to the middle pinch
roller.
• Move both the left and middle pinch rollers
together until they reach the right stop.
• Load the media so that the left side of the narrow
media is under the left pinch roller.
• Adjust the right pinch roller over the right side of
the media.
• Raise the media set lever to lower the pinch roll-
ers.
• Lower the pinch rollers (raise the lever) and pull
the vinyl out from the alignment bar. Turn on the
power if it is off.
• Plotter performs the initialization routine.
V 5.00 GL
Buffer RAM Checking
• Loading of the media is complete.
To load rolled media:
• Place the roll of media on the media stocker. Use the yellow markings to locate
the grit rollers. Place the media so that its edges align with the grit rollers.
Roller Location Guide
Pre pa rin g t o C ut : L oa di n g Me di a
41
Good Pinch Roller Position